Here is our problem. We use the 3.6.x client to tunnel into our network from remote locations. In one of these locations we recently installed a router which feeds ip address to 2 computers and 1 printer. When we activate the VPN client we no longer can print to the printer. I assume that the VPN tunneling grabs the printer traffic and tries to route it to our network. The simple question is, is it possible to set up the client to pass the printer traffic to the local LAN while the VPN is activated? Any help is greatly appreciated.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...