Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Lock and Key ACL (Dynamic ACL) outbound on dialer interfaces?

I am try to set up Lock and Key ACLs on dialer interfaces on a 2610. I want it for outbound traffic. Everything looks ok. However, when I telnet to the dialer interfaces IP and log in I get a message saying:

No input access group defined for Ethernet0/0.

What little information I can find on Lock and Key indicates you can put the ACL on any interface in or out. I am missing something here? Here is the part of my configuration that addresses the Key and Lock ACL.

Current configuration : 29521 bytes


version 12.2

service timestamps debug datetime msec

service timestamps log datetime msec

no service password-encryption


hostname router

username testuser password testpass


interface Ethernet0/0

ip address

ip nat inside


no cdp enable


interface Group-Async1

no ip address

encapsulation ppp

dialer in-band

dialer pool-member 1

async mode dedicated

ppp authentication chap

group-range 33 40


interface Dialer1

description testdial

ip address

ip access-group 102 out

ip nat outside

dialer pool 1

dialer remote-name remotesite

dialer idle-timeout 45000

dialer string 628

dialer-group 1

no cdp enable

access-list 102 remark Testing Dynamic ACL

access-list 102 dynamic testacl timeout 120 permit ip any any log

access-list 102 permit tcp any host eq telnet

access-list 102 deny ip any any log

line vty 0 4

password termpass

login local

autocommand access-enable timeout 5


Thanks Much!!!

Chuck Glover

Cisco Employee

Re: Lock and Key ACL (Dynamic ACL) outbound on dialer interfaces

Answered this on the Security NetPro forum list.

CreatePlease to create content