Is there a way to set up a lock and key acl for a host behind the ethernet segment on a router?
i will be attempting to access this host over a serial connection, but I need to add 'permit ip any any' on the acl because it will be appllied on the serial, thus defeating the purpose of the acl in the first place.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...