Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Logging Commands

If I don't have "aaa accounting commands" configured, will I still be able to capture all commands entered if I have my logging traps set to debugging? i.e., what is the significant difference between the two? Don't both methods achieve the same objective? Thank you!

2 ACCEPTED SOLUTIONS

Accepted Solutions
Silver

Re: Logging Commands

No, debugging will not log commands typed. Debugging will log just about everything ele, and will log a message saying that the device was configured by xxx when you exit config mode, but it does not show every command. The only way I know of to do that is with aaa accounting.

-Eric

Gold

Re: Logging Commands

PIX OS will log individual commands typed in if you have it set to the right logging level, IOS will not.

2 REPLIES
Silver

Re: Logging Commands

No, debugging will not log commands typed. Debugging will log just about everything ele, and will log a message saying that the device was configured by xxx when you exit config mode, but it does not show every command. The only way I know of to do that is with aaa accounting.

-Eric

Gold

Re: Logging Commands

PIX OS will log individual commands typed in if you have it set to the right logging level, IOS will not.

150
Views
0
Helpful
2
Replies
CreatePlease to create content