Need help on logging by Cisco 3640 Router with Version 12.0(7)XK1.
With an Syslog server in places, I create an access-list that permit tcp any any log and apply it on the serial interface as input access list. I notice that not all-incoming packets are log. I have also activated the logging console.
I have turn off IP route-cache for all the serial and fastE interface as well
If there is any changes in the interfaces status it was log.
From both the console and the Syslog server I confirm that not all incoming packet are log.
What should I do in order to track all packets passing through the serial interfaces.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...