Did you set up the authorization or just authentication through Tacacs+?
I recently had an issue with this, but I was able to login. I wasn't able to see the devices however. It turns out that the devices in CSM need to be the same exact display name as they show up in ACS.
After some headache I just used ACS for authentication, and not authorization. To do this you choose "non-ACS" when you are setting it up just put the radio button in tacacs+. You then add the user in the local database for the authorazation piece. But it will authenticate against tacacs.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...