Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Looking for example config help

I am trying to get a PIX 506 (6.22) connected via a cable modem with a dynamic IP address to do a site to site VPN with a PIX 520 (6.22) with a static IP. The 520 also has two other Site to Site VPN's terminateing on it useing static IP's on each end. I had no problems getting the vpn's up on the static ip's, but nothing I seem to do works to get the dynamic to static running.

Could someone share a working dynamic to static config snippit for both sides of the VPN?

Thanks

Miles

1 REPLY
Cisco Employee

Re: Looking for example config help

Hi,

Below you will find a sample config for Dynamic to Static IPSec:

http://www.cisco.com/warp/public/110/dynamicpix.html

Regards,

Arul

87
Views
0
Helpful
1
Replies
CreatePlease to create content