Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Low level reset.

Hi,

I have heard that you can do a low level reset or something on a Cisco concentrator 3000. We have had a lot of strange problem with this device, we deleted the config file, but it doesn’t fix the problem. Is it possible to do total file system reset?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Low level reset.

Hi

In routers normally we use the passwd recovery procedure to bring that to default state.

but in concentrator i think u can use up the 7th option mentioned in the below link to load without any config file..

http://www.cisco.com/en/US/products/hw/vpndevc/ps2284/products_configuration_example09186a008014c1ba.shtml

regds

2 REPLIES

Re: Low level reset.

Hi

In routers normally we use the passwd recovery procedure to bring that to default state.

but in concentrator i think u can use up the 7th option mentioned in the below link to load without any config file..

http://www.cisco.com/en/US/products/hw/vpndevc/ps2284/products_configuration_example09186a008014c1ba.shtml

regds

New Member

Re: Low level reset.

Thanks,,

Problem solved.

113
Views
0
Helpful
2
Replies