Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Man 0/0 on Standby ASA - speed/duplex

I noticed the hard coded speed and duplex settings for interface Management 0/0 do not replicate from the primary to the standby ASA. Do I have to manually hard code these on the secondary? Will the settings keep after the unit restart since it gets its config from the primary?

We are using this as the failover interface.

2 REPLIES
New Member

Re: Man 0/0 on Standby ASA - speed/duplex

I know that Cisco suggests that you dont use the Managment interface for your failover interface... but thats another issue all together. If you use the montior-interface command on Managment it should provide you with some more information (not positive but its worth a shot)

Cheers,

Chris

New Member

Re: Man 0/0 on Standby ASA - speed/duplex

I ended up hard coding the speed/duplex on the standby ASA. This appears to have fixed the problem. Even after restating, the settings stayed.

115
Views
0
Helpful
2
Replies
CreatePlease to create content