Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Management-access command on PIX 7.04 and 7.1

Am I missing something or is the "show management-access" command no longer available in PIX code 7.04 and 7.1?

DCSSwedenPix(config)#show management-access ^

ERROR: % Invalid input detected at '^' marker.

DCSSwedenPix(config)#

"management-access inside"" is in the config but it does not seem to be functioning properly.

Anybody else see this issue?

Thanks!

DC

1 REPLY
Gold

Re: Management-access command on PIX 7.04 and 7.1

i just had a look at the command reference and the code is "sh management-access", however it returns an error.

i had a play and find out the correct code is "sh run management-access".

115
Views
0
Helpful
1
Replies
CreatePlease to create content