When was the last time you generated rules? It looks like Oct 17th and there may be too many. If the number of database items exceeds the complexity threshold (7500, I think), rule generation will fail.
You may need to go in an delete some items before it will generate successfully.
Also check that the file it is trying to generate from is still present.
Don't pay attention to the date. It's only a fragment from the log. The point is that during the installation of MCCSA there was already a message about the mistake of rule generation (see log CSAMC60-Install.log). After installation in MCCSA the state of rules in the state line is as follows: 1044 rule changes pending. When I try to generate them there is a message about a mistake - Failed to prepare rules: Cmd_BulkInsert failed.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...