Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Management of a Cisco 3030 using HTTP from different subnet

I recently installed A Cisco 3030 Concentrator and the IOS was 3.0.X, I finally got it configured so I could manage the VPN from 10.129.69.X, the VPN both public and private IF's were on 10.129.72.X. I then upgraded the IOS to 4.1.2 now I can only manage the VPN from the same subnet 10.129.72.X, I can not even ping the public or private except from the 10.129.72.x subnet, but I could before the upgrade. Does anyone know what I am doing wrong? When I did the upgrade I chose to keep the current configuration.

1 REPLY
New Member

Re: Management of a Cisco 3030 using HTTP from different subnet

Check your route table. ("monitoring>route table", add routes in "configurations>system>ip routing", add routing protocol "configurations>interfaces>interface")

Check what filters are applyed to the interfaces(private/public/other)

interface are active ("configurations>interfaces>interface")

p.s. the two interface should be on different LANs?

94
Views
0
Helpful
1
Replies
CreatePlease to create content