I have a problem with a customer who authenticates all of his outbound http and https traffic on a proxy. I need for our software to connect outbound from his network on tcp port 44444, and then map that tcp port to 443 on my network before is hits my servers. I have a PIX and a CSS 11051. I have not had any luck with either. Any suggestions?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...