To permit connection in both directions you can use the classic "static" command, but, for map some private IP onto the same public IP you must use the port redirection, to specify the correct TCP or UDP port:
My intension was that these two systems should have a bi directional communication with a windows vpn server using the same public address.
I opened up port 1723 and gre port using conduit statements
When first tried to connect from 10.1.2.1 it connected successfully. But when i tried to connect from the second system using same windows vpn i am getting an error message like
The Specified port is not connected.
When gave show xlate command i seen the first command
global x.x.x.x local 10.1.2.1 static.
I disconnected from the 10.1.2.1 system and after two hourse(since xlate timout was 1:00:00) from the 10.1.2.2 system but still the same error. I removed the static mapping for the 10.1.2.1 but when i typed in
still that mapping is there and it is not removed.
Can you please advice me how to go about for this problem
Re: Mapping of Single public with many private ip address in cis
Thanks a lot for your mail.
Since i have alreadu nat (inside) 1 192.168.1.2
nat (global) 244.x.x.1
Will the new nat does not harm them? Should i use the same nat id 1 or can i use a different id. If i configure as you said above. All the different private ip addresses will go with the global address? Like i can map the global 244.x.x.1 with all public address or should i use different public address?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...