Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
SAP
Community Member

MARS 20

Hi Everyone,

recently installed MARS appliance. After a few days i was not able to connect to the device any longer. when I console onto the box i keep see pop up (like the boot sequence) that the loopback and network card is ok. but when i check the interface the config isn't there anymore. further more, i configure it and it reboots, but doesnt take the config.

has anyone seen this before? firmware is 4.3.1

1 REPLY
Silver

Re: MARS 20

The first time you boot the appliance and whenever you re-image it, you must configure the MARS Appliance.

Before you begin to configure the appliance, you can ensure whether the instructions given in the below URL has been completed.

http://www.cisco.com/en/US/docs/security/security_management/cs-mars/5.3/installation/guide/setup.html#wp1151176

113
Views
0
Helpful
1
Replies
CreatePlease to create content