Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

MARS Installation errors - beep codes

Hi all,

I'm imaging a 100E with 4.2.1, newly purchased had 3.x on it, and I'm getting an error beep code when I get to the "making disks" part.

I get 2 quick beeps - pause - 4 quick beeps.

Now, if I reboot the box, the beeps start immediately. I reseated the disks and power supplies, no change.

The install doesn't fail, or stop (from what I can tell) it seems to be writing to the disks - as evidenced by the led's flashing.

Any suggestions?

I've tried installing the recovery image disk that it came with, but the same thing happens.

Thanks,

Bob

1 REPLY
New Member

Re: MARS Installation errors - beep codes

Per Cisco:

"Root cause of 2 beeps followed by 4 beeps is as follows.

This has been debugged by the hardware team and has been determined to be caused due to backwards fan assembly."

Resolution:

Return the box for a new one.

Bob

117
Views
0
Helpful
1
Replies
CreatePlease to create content