Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Match address and routing

I have a couple of tunnels which I am passing GRE over to obtain routing information and these work OK. However if i do not want to pass GRE over a tunnel could I use a static ropute eg ip route x.x.x.x x.x.x.x tunnel1. What effect would this have ?. Furthermore is the 'match address' statement effectively a route to the destination network ?. Does it mean that all traffic matching the access list is immediately sent down the tunnel the match address is defined in regardless of whether a route exists or not. I have read lots of stuff on this but I just want to get this clear in my head as I may need to create 40 + tunnels.

1 REPLY

Re: Match address and routing

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

97
Views
0
Helpful
1
Replies