Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cisco Employee

max number of Ethernet interface supported on 6.2(2)

Good morning,

I have a pix 525 UR with Pix 6.2(2) version. I am fingind any confirmation about the maximum number of physical interface supported. I think they are 10, but I found confirmation of it in the 7.0(1).

Is it the same case for the 6.2(2)?

Any link to confirm it in the CCO?

Thanks

4 REPLIES
New Member

Re: max number of Ethernet interface supported on 6.2(2)

Hi Macardell

You can see the maximum number of interfaces with the command "Show ver"

This command returns as following:

...... (omited output)

.......

Maximum Physical Interfaces:3

Maximum Interfaces: 5

....

....

The Maximum Physical Interfaces is the number of phisical interfaces, and Maximum Interfaces includes virtual interfaces.

I hope this can help you.

Best Regards

Roberto

Cisco Employee

Re: max number of Ethernet interface supported on 6.2(2)

Thanks,

Have you got any link that can confirm it?

If I do not have the card still I cannot really check it.

Is the output you got from a 525 UR?

Cisco Employee

Re: max number of Ethernet interface supported on 6.2(2)

Thanks,

Have you got any link that can confirm it?

If I do not have the card still I cannot really check it.

Is the output you got from a 525 UR?

New Member

Re: max number of Ethernet interface supported on 6.2(2)

It is a command you can use in any platform and any version.

Here you have the link you requested.

http://www.cisco.com/en/US/partner/products/sw/secursw/ps2120/prod_release_note09186a00801a6d21.html

I put the output for PIX 525UR.

Regards

Roberto

101
Views
3
Helpful
4
Replies
CreatePlease to create content