Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Modem configuration

Dear sir,

I have cisco router 2610 with one direct line and one US robotics modem conected to my AUX port

what I am looking for to use this line or this modem

for outgoing call like Dial on demand and for incoming call, my question is how can I configure my router to do that, or how can I configure my async interface to do that

Note my IOS ver is 12.0

Thanks

1 REPLY

Re: Modem configuration

The focus of this forum is Network Management of Virtual Private Networks however there are a number of professionals online who may be able to assist you. We are always considering additional forums for such topics and I will make a note of your post.

If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (www.cisco.com/tac) or speak with a TAC engineer.

This url might be a good place to start:

http://www.cisco.com/warp/customer/471/index.shtml#async

Should you need to, you can open a TAC case online at www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

335
Views
0
Helpful
1
Replies
CreatePlease login to create content