Thanks a lot for the prompt reply. I only have two final questions:
q.1 When pushing detection signature configurations changes to the sensors using MC, the changes are finalized following 5+minutes of high overhead for each push. After which the changes effected can be viewed immediately. On the IDM it requires that you log off and log on -but sometimes the changes are not effected when you log back into the IDM the second or third time. On the CLI the changes are effected within 10-20 seconds but I have not found a method of verifying the changed settings.
q1 So my question is how long does a change for a change to have been effected through the IDM.
q2 Is there a way to verify the new settings of a signature through the CLI
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...