Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Module CSC in a Cisco ASA 5520 doesn?t analize any traffic

I am trying to configure a module CSC in a Cisco 5520. In the ASA, I have:

FWASA# sho module 1 details

Getting details from the Service Module, please wait...

ASA 5500 Series Content Security Services Module-20

Model: ASA-SSM-CSC-20

Hardware version: 1.0

Serial Number: <serial number>

Firmware version: 1.0(11)2

Software version: CSC SSM 6.1 (Build#1519)

MAC Address Range: 0018.199e.a2ee to 0018.199e.a2ee

App. name: CSC SSM

App. Status: Up

App. Status Desc: CSC SSM scan services are available

App. version: 6.1 (Build#1519)

Data plane Status: Up

Status: Up

HTTP Service: Up

Mail Service: Up

FTP Service: Up

Activated: Yes

Mgmt IP addr:

Mgmt web port: 8443

Peer IP addr: <not enabled>

But the module CSC it doesn?t work, because it doesn?t analize any traffic. All traffic counters are 0.

have I have to do anything special to activate the CSC module?.

Best Regards

Thank you very much



Re: Module CSC in a Cisco ASA 5520 doesn?t analize any traffic


Have you configured a service policy to direct traffic to the CSC? If so, can you post the config?



New Member

Re: Module CSC in a Cisco ASA 5520 doesn?t analize any traffic

Yes, finally I configure the service policy and the CSC started to analyze traffic.

However I had have to disable this module because:

-The conections FTP SSL don?t work.

-The proxy squid does?nt work. It appears a message of "URL malformed".

So, what kind of policy I have to activate?.

Thank you very much.

Best Regards.