Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

monitor dial access - usernames and ip's

Hi,

I have aaa auth and snmp / syslog running on my Cisco3640 for dial in users. The users are authenticaticated against a Win2k box and the resulting connection info is sent to my syslog/snmp server.

The problem is the info is not very good. It basically only shows if the port has come up and when it goes down again ( i.e. Async 85 up ). I would like the syslog / snmp server to show the username and if possible the assigned dhcp address for all dial in users.

Is this possible ?

I have looked under snmp-server traps and accounting and cant seem to see the correct command set.

Any thoughts ?

cheers

Richard

1 REPLY
New Member

Re: monitor dial access - usernames and ip's

I think you will have to configure syslog at level 4 or 5 for logging the messages for users logging in through dial up. Following links may help you

http://www.cisco.com/en/US/products/sw/cscowork/ps2073/products_tech_note09186a00800a7275.shtml#topic1

http://www.cisco.com/en/US/products/sw/cscowork/ps563/products_user_guide_chapter09186a00801a9564.html

96
Views
0
Helpful
1
Replies