Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Move nameif to another interface

Is there an easy way to move the configuration from one interface to another. I want to move "nameif dmz" from eth2 to eth3 and in the past once I removed or renamed the original interface the pix would remove or rename the config for that nameif. I hope this makes sense.

2 REPLIES
Hall of Fame Super Gold

Re: Move nameif to another interface

Harold

I am not aware of any way to have the PIX transfer the dmz configuration from one interface to another. If it were me I would do show run, then copy and paste the config statements relative to dmz into a text file. Then in the text file I would prepare "no ..." statements to remove dmz from eth2 and change the config statements for dmz to eth3. Then go into config mode and cut and paste the commands from the text file into the config.

HTH

Rick

Community Member

Re: Move nameif to another interface

Thats what I was afraid of.

Thanks for the reply.

301
Views
3
Helpful
2
Replies
CreatePlease to create content