Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Moving configuration between PIX's

Hi,

Is there a documented procedure for moving config's between PIX's? Basically we have a PIX cluster (515's running 6.2) and want to test the upgrade. So we've borrowed another 515, put our running config on to it - but suprise, suprise can't login. I assume mis-matching keys for AAA etc. Not knowing too much about this I'm wondering if there is a set procedure for dealing with this? I assume there is since people replacing hardware must happen quite often. Tried searching the knowledge base but....

3 REPLIES

Re: Moving configuration between PIX's

You have to do a password recovery !

See this document:

Password Recovery and AAA Configuration Recovery Procedure for the PIX:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_password_recovery09186a008009478b.shtml

sincerely

Patrick

New Member

Re: Moving configuration between PIX's

I've done that and no joy!!!

Bronze

Re: Moving configuration between PIX's

Have you loaded the password recovery file through tftp, and you still could not erase the password????

It should work, make sure you are downloading the right file (for 6.2) and make sure you loaded through tftp, and it should work fine...

Regards,

90
Views
0
Helpful
3
Replies
CreatePlease login to create content