Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Moving from 6.3 to 7.0

I currently have PIX 515 setup running ver 6.3(5) in an active/standby configuration. I was wondering if it is possible to upgrade these to 7.0 and run them in an active/active configuration.

2 REPLIES
New Member

Re: Moving from 6.3 to 7.0

Active/Active is only useful if you runing mutiple contexts. It's not much of a use if in single mode.

New Member

Re: Moving from 6.3 to 7.0

Thanks for responding. Here is the kicker on this, our director wants to hook the 515's back to back with the 2811's at this location. The 2811's are both connected to our MPLS network via BGP and he wants both of those to load share across the wan hence the question about upgrading. The firewalls are being used to block a customer network at our remote location and allowing only certain TCP apps through.

129
Views
0
Helpful
2
Replies
CreatePlease to create content