Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

MPLS causes MARS unconnected "clouds" on serial interfaces

In MARS we have a graphical layout of our network and athe things being monitored.

When the routers to our branch routers are shown, since the the serial interfaces are on two host point to point networks, the serial interface is connected to a cloud.

Each branch connects to a seperate cloud.

Is there any way to have all branch serial interfaces go into the same cloud?

3 REPLIES
Silver

Re: MPLS causes MARS unconnected "clouds" on serial interfaces

Hi Richard,

There is no way at present that I am aware of to do this. It's a fairly common request from my customers to have a greater ability to customize the graphical layout of the network map. I have made this request to Cisco to add this functionality.

Hope this helps.

Paul

Community Member

Re: MPLS causes MARS unconnected "clouds" on serial interfaces

Thanks,

Very helpful.

Bronze

Re: MPLS causes MARS unconnected "clouds" on serial interfaces

At one point I thought about creating a 'fake' router in MARS that would have interfaces with IP addresses that correspond to the PE (Provider Edge) MPLS routers. This would mean creating a "Generic Router version unknown" in MARS and standing up a 871 or something so that MARS can SNMPWALK it.

Afterwards I thought you could add the PE interfaces and the maps would glue the subnets together. I haven't tried this yet, but in theory it should work, right?

120
Views
5
Helpful
3
Replies
CreatePlease to create content