Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Multiple ISP natting with single private IP in PIX

HI,

I do have 2 ISP terminating into Cisco PIX. I do have internal server in LAN zone. I wan to do natting the private ip of the server with 2 ISP's simultaneously. Is this possible?

6 REPLIES

Re: Multiple ISP natting with single private IP in PIX

The NATing is possible, but what will you do about the default routes? The PIX supports default routes pointing out to only ONE of its interface at the same time, not more than one.

Or this is an active/backup scenario?

Farrukh

New Member

Re: Multiple ISP natting with single private IP in PIX

you can nat private ip address of server with 2 ISP's public ip address.... but only one will work at a time. When ISP1 goes down the server is access via ISP2 public ip address and vise-versa.

It will only work in Active\standby scenario.. same goes with your internet traffic.

Regards

Manjeet

New Member

Re: Multiple ISP natting with single private IP in PIX

Hi,

I do have only 1 pix.

If such solution is possible iwth pix then why should people go with Radware such device???

Re: Multiple ISP natting with single private IP in PIX

Other firewalls in the market support this, Cisco PIX does not.

Regards

Farrukh

New Member

Re: Multiple ISP natting with single private IP in PIX

Hi,

Sorry, i missed the last part. We need to make sure PIX should be running 7.x IOS image

Here is the link for your reference:-

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806e880b.shtml

New Member

Re: Multiple ISP natting with single private IP in PIX

Hi,

Sorry, i missed the last part. We need to make sure PIX should be running 7.x IOS image

Here is the link for your reference:-

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806e880b.shtml

120
Views
0
Helpful
6
Replies
CreatePlease to create content