08-30-2008 08:15 AM - edited 02-21-2020 02:59 AM
HI,
I do have 2 ISP terminating into Cisco PIX. I do have internal server in LAN zone. I wan to do natting the private ip of the server with 2 ISP's simultaneously. Is this possible?
08-30-2008 11:02 AM
The NATing is possible, but what will you do about the default routes? The PIX supports default routes pointing out to only ONE of its interface at the same time, not more than one.
Or this is an active/backup scenario?
Farrukh
08-30-2008 06:33 PM
you can nat private ip address of server with 2 ISP's public ip address.... but only one will work at a time. When ISP1 goes down the server is access via ISP2 public ip address and vise-versa.
It will only work in Active\standby scenario.. same goes with your internet traffic.
Regards
Manjeet
08-30-2008 09:51 PM
Hi,
I do have only 1 pix.
If such solution is possible iwth pix then why should people go with Radware such device???
08-30-2008 10:38 PM
Other firewalls in the market support this, Cisco PIX does not.
Regards
Farrukh
08-30-2008 11:00 PM
Hi,
Sorry, i missed the last part. We need to make sure PIX should be running 7.x IOS image
Here is the link for your reference:-
08-30-2008 11:10 PM
Hi,
Sorry, i missed the last part. We need to make sure PIX should be running 7.x IOS image
Here is the link for your reference:-
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide