Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Multiple mGRE spoke tunnels from 1 device to the hub possible ?

Hi,

Is it possible to configure more mGRE spoke tunnels from 1 device possible to the same hub device?

10.0.0.0-R-spoke -------- R-hub-11.0.0.0

-------/

1 mGRE

This would allow loadsharing over multiple paths from the R-spoke to the R-hub

or do you have to configure more mGRE tunnels between the 2 devices to make this work?

Kind regards,

Renaat Leuridan

2 REPLIES
Bronze

Re: Multiple mGRE spoke tunnels from 1 device to the hub possibl

The ability to configure two mGRE tunnels with same tunnel source on one router already exists as a feature request (bug CSCea16812). You can track the same and see where it goes.

New Member

Re: Multiple mGRE spoke tunnels from 1 device to the hub possibl

Thanks for the reply, but is it also possible to configure from 1 router-spoke a mgre tunnel to 1 destination address, but with differnt source ip addresses (of the parallel connected physical interfaces towards the hub) ?

110
Views
0
Helpful
2
Replies