Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multiple Nat Statements on the firewall?

Is it possible for and inside host to use two Nat statements on the firewall. I have a global statement setup (for PAT'ing), I also have a one to one NAT setup for a workstation on the inside network. Is there a way to allow the inside workstation to use the one to one NAT if it is sourced to a specific destination and for all other destinations it will use the global NAT?

1 REPLY
New Member

Re: Multiple Nat Statements on the firewall?

Yes-- look at policy NAT. You config an ACL to identify the 1:1 NAT conditions, then set the default NAT and the static nat as "static access-list". If you search for this, you'll find examples

270
Views
0
Helpful
1
Replies
CreatePlease to create content