Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Multiple Port Forwarding @ PIX 6.3

I know how to do it when it is only one port but when it is say 2000-2120 UDP of course I cannot enter 120 commands. How can I do that in PDM or CLI ? thanks

And I also want to know the syntax for the ASA...

1 REPLY
Silver

Re: Multiple Port Forwarding @ PIX 6.3

Unfortunately, there is still no way you can do port-redirection for a range of ports using a single command. Still we need to use a command for each single port, which means 120 commands in this case .. :-(

Regards,

Vibhor.

143
Views
0
Helpful
1
Replies