I'm able to successfully create two different ipsec tunnels and I need them to both be operational at the same time. However, when I "crypto map" to the outside (physical) interface of my PIX 515, only one of them is operational at once. The tunnels go to two different locations, different peers and different shared keys. Do I need to setup a logical interface and map to that for each or what? Any help is appreciated. I apologize if I didn't spend enough time searching the forum for a answer, but I did try :-). If you could point me to a configuration example for this, that'd be great. Thanks in advance for your help.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...