Multiple VPN tunnels from remote IOS routers to a central PIX
I have 4 remote Routers (2610 with 12.2 software) and a central PIX 515 (PIX6.1 software) and I want to create VPN tunnels in a HUB-and-SPOKE topology (all the VPNs terminated to the central PIX). When I configure only one VPN on the PIX (for one of the sites) it works great. However, by the time I add a second (or more) VPNs, by adding additional instances in the "crypto map MYVPN....." command, nothing works. The configurations are correct for sure, but I don't know why nothing works when I add more than one VPN on my PIX. Anybody found similar problem?
Re: Multiple VPN tunnels from remote IOS routers to a central PI
We had the same problem in the start so I've been there...
If you drop me an e-mail I will be able to send you a sample config which you would be able to use. The reason why I can give it to you right now is that I am travelling in the U.S. but I'll be back in my office monday (13/5) - interrested ?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...