I would like to configure multiple vpngroups on a pix 515 running 6.1(4) code. Clients will be outside PC's running cisco secure client for whatever OS they run. I have configured access for one group already can I get a link to tech article that shows config for multip vpngroups? I have questions on access list, isakmp policy and dynamic-map areas of configuration.
Basically isakmp policy is not configured per group, the VPN client will run through each policy from the top down until it finds a match, you can't have one group use this policy and one group use that policy. Same goes for dynamic-crypto maps and the transform set.
Access-lists for split tunnelling can certainly be dofferent, as can address pools and WINS/DNS servers.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...