Hi this is my first time setting up a mVPN so not sure if I'm set up the right way. I'm guessing that I'm not as I don't see any mcast packets on my router what can I do to double check I'm set up correctly? The tunnel is up and I can hit their server, when I do a show ip mroute I don't see anything. Anything else that I can verify??
Thank you for the info...I found out that my route wasn't pointing to the tunnel it was going out a different interface. Once i pointed my traffic to the tunnel all was good. thank you for the link it helped me better understand all this. Thanks for your help!!!!!!
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...