My applications that pass through pix is JDBC and MQ were constantly droped
I have some applications in my enviroment that has excetionally long connection timers that being dropped by the pix. Please tell me how config the long connections basing on different applications?
My applications that pass through pix is JDBC and MQ.TO keep alive the connections of the applications.The applications have to send hello packets every a few seconds.Which will consume a plenty of the resource of network.What configuration can I do.Please help me .
Re: My applications that pass through pix is JDBC and MQ were co
For LAN-based failover, the configuration on the two units differs slightly, because you must set up the Ethernet link in advance. You must also define each unit as a primary or secondary unit within the configuration (as opposed to cable-based failover, where the serial failover cable itself defines these roles). The active unit sends the configuration in running memory to the standby unit. On the standby unit, the configuration exists only in running memory. You can optionally save the configuration to Flash memory using the write memory command. If you save the configuration to Flash memory, and you reboot the standby unit when the active unit is unavailable, the standby unit can become the active unit because it has a valid configuration.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...