Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

NAC 4.6

Hello all,

I'm having a problem with NAC 4.6.1 and agent 4.6.2.113. If a client already has an older CAA installed they get prompted to upgrade and it works fine. However, if no agent is installed and you try to install it from the http page, it acts like it is installing then installs the web agent. I can manually install the 4.6.2.113 agent on the client. Yes, the user is an administrator. I uploaded the 4.5.2 agent and the clean install works fine.

Any ideas?????

3 REPLIES
New Member

Re: NAC 4.6

WOW! Great Forum. Thanks for all the help!

New Member

Re: NAC 4.6

Have you checked your settings for the role?

go to Device Management > Clean Access > General Setup > Agent Login

Select the role the user belongs to and unclick webagent and click agent and try that.

New Member

Re: NAC 4.6

That was one of the first things I checked. This really stinks because we are having to install the agent manually.

I found other blogs where people are having the same issue and none have corrected it yet.

I can call TAC but from past experience, well not impressed with NAC support.

123
Views
7
Helpful
3
Replies
CreatePlease to create content