Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAC appliance basic setup

I have a small project to authenticate around 100 users to access the network. We are planning to use the Cisco NAC appliance. Just to clarify (I have seen some post but I am not sure of the right answer) Do I need 2 separate appliances, one as server and the other as controller; or I just need one doing both tasks?

Thanks,

-Arturo

2 ACCEPTED SOLUTIONS

Accepted Solutions
Silver

Re: NAC appliance basic setup

Hi Arturo,

You need two appliances to make it work. One manager and one server.

There is an excellent book from the Cisco Press on the NAC Appliance by James Heary which will provide you with plenty of details and background on setting up the appliances.

Hope this helps.

Paul

New Member

Re: NAC appliance basic setup

Hi,

U need 2 devices to scatter this service. 1 will act as server who will push all policies to the end clients & the other will work as manager where the config will be done.

Rate if it helps

2 REPLIES
Silver

Re: NAC appliance basic setup

Hi Arturo,

You need two appliances to make it work. One manager and one server.

There is an excellent book from the Cisco Press on the NAC Appliance by James Heary which will provide you with plenty of details and background on setting up the appliances.

Hope this helps.

Paul

New Member

Re: NAC appliance basic setup

Hi,

U need 2 devices to scatter this service. 1 will act as server who will push all policies to the end clients & the other will work as manager where the config will be done.

Rate if it helps

97
Views
8
Helpful
2
Replies