Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

NAC appliance local authentication not working

Hi,

i am trying a test scenario for NAC. it is oob virtual gateway

I get the login page when i try to access the web but when i try to authenticate to the local db i don;t receive an error message and i remain on the authentication screen.

I listened with tcpdump on both interfaces. on the untrusted side i see traffic but on the trusted side no diffrence in traffic appears(but maybe this is normal)

can someone please help with the detailed steps the authentication follows

not just host->nas->nam(localdb)

or some ideas

Thank you!

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: NAC appliance local authentication not working

check for the teporary certificates that you generated and set the FQDN field to the nas ip address and so with the nam

3 REPLIES
New Member

Re: NAC appliance local authentication not working

check for the teporary certificates that you generated and set the FQDN field to the nas ip address and so with the nam

New Member

Re: NAC appliance local authentication not working

Thank you, that was the issue.

New Member

Re: NAC appliance local authentication not working

I doubt this will help, but here goes. I seem to remember a similar issue here, and I went into my browser's proxy settings and turned them off. Then I could authenticate, but not browse the web. So after authenticating I turned them back on and it was fine. There is a tab on the NAC Device Management > Clean Access Servers > >Advanced> Proxy where you can tell clean access about a proxy server, but I don't know if that's relevant.

I assume you have verified that your local user ID works by testing the auth server with it and that it has a profile that allows you to go someplace.

116
Views
0
Helpful
3
Replies
CreatePlease to create content