I have a recently installed CAM that doesn't have any rules or av lists so the drop down for av says update av list. when i go to the update tab I get a message saying it found no updates. The request is not timing out the message comes up instantly after clicking update. Are there any known issues with updating? This is kind of a big issue because I can't create any rules or requirements until this happens and I can't test the system without those rules.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...