Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAC CAS HA question

Hello,

I currently have an IB and OoB VG environment. Both CAS are working fine, but now I want to add HA to both. Looking at te documentation (CAS user guide 4.1.3) I see I need two Service IP Addresses, one for the trusted interface and one for the untrusted. In my case since they ar running in VG mode, iwould normally have the same ip address in the trusted and untrusted sides. Does the same apply for the Service IP Addresses? should I use the same service ip on both sides??

Do I need in total three IP's 1 for both int's of the IB CAS, 1 for both int's of the OoB CAS, and 1 for both Service IP Addresses??

Thanks in advance for any info...

1 ACCEPTED SOLUTION

Accepted Solutions

Re: NAC CAS HA question

For a VGW solution, you would use the same IP address for trusted and untrusted.

You will need three IP addresses: Real Primary, Real Secondary, Service IP. This is per system not per interface.

2 REPLIES

Re: NAC CAS HA question

For a VGW solution, you would use the same IP address for trusted and untrusted.

You will need three IP addresses: Real Primary, Real Secondary, Service IP. This is per system not per interface.

New Member

Re: NAC CAS HA question

Thanks Dan!!

150
Views
0
Helpful
2
Replies