I'm trying to configure NAC for Remote VPN users, I'm plaining to use the VGW mode.
I configured both E0 and E1 with the same IP address, I tried to verify connectivity to both interfaces using my PC with a cross cover cable. When I'm connected to E1 I can issue a ping, but when using E0 the ping doesn't pass.
Is this a normal behavior???
with this issue, the CAM can't connect to the CAS.
If the CAM fails to import the CAS, make sure that connectivity is not an issue. You can attempt to ping the CAS from the CAM CLI when you log in as root. You can also attempt an SSH connection from the CAM to the CAS. Make sure that you have done the initial configuration in the CAS. You can use the service perfigo config command in order to initialize the CAS via its CLI.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...