NAC - How to troubleshooting network scanning not working
I'm testing Cisco NAC agentless in-bound layer2 mode following the CAM manual:
â¢Configure the Quarantine Role
â¢Load Nessus Plugins into the Clean Access Manager Repository,
â¢Configure General Setup,
â¢Configure Plugin Options,
â¢Configure Vulnerability Handling,
â¢Test Scanning (I can successfully "test from Manager" from "test" tab)
I'm sure I disabled personal firewall on the testing client on untrusted vlan.
When I using a testing PC to open a browser to access internet, I was redirected to the authentication pape, after login, I got unlimited access. The problem is It looks CAS did not do any scan to the PC as expected according to the policy I defined for "unauthenticated" role, there is no any scan report poped up.
1.Any way I can check if Nessus Scanning is working properly on CAS?
2.Any log or evidence I can check to make sure the scanning start, in process, complete , so I can know the status.
3.How to check all plugin already pushed and sycronized by CAM?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...