Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAC - Issues with Switch, CAM and SNMP

I am installing a CAS and a CAM for the first time. My first step is to change vlans in 2950 switch, using the CAM.

My topology is out-of-band real ip gateway.

I have the switch in CAM, I configured port profile (auth vlan (10), default access vlan (11) and access vlan (11)). I also assign this new port profile in one port of the switch.

By default I put the access vlan (11) in all switch ports.

My problem is when I connect a PC to the port controled by the CAM. CAM should change the port from vlan 11 to vlan 10 and I cannot acheive that.

This way I can not test PBR, and the CAS.

I also tried to put the controled port on auth vlan (10) and the auth page is not displayed in the browser.

Can you give me a help?

Best regards,

Jo?o Carvalho

108
Views
0
Helpful
0
Replies
CreatePlease to create content