Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAC - "unable to control" Cat4500-E

I recently had a issue with conecting Cat4500-E switches with SupIV to CAM. I have recieved error message "unable to control x.x.x.x".

Whole problem was switch OID not in the database of CAM.

For those experiencing the same problem go to on the CAM:

Device Management > Clean Access > Updates > Update

CHECK "all" options and RUN UPDATE!

You need internet conectivity for sure.

Hope this helps the others.

Marian

1 REPLY
New Member

NAC - "unable to control" Cat4500-E

Thanks Mstefanka,

The steps  you indicate solved the problem I had in days.

Roni

771
Views
0
Helpful
1
Replies
CreatePlease login to create content