The nat-control statement mandates that a translation policy be defined before hosts on the inside can send traffic out. Without this statement the appliance does not require the address to be translated.
Note that even with nat-control you can bypass translation by using "Identity NAT" or "NAT exemption"
Another way to look at having the nat-control statement is that if packets matches a nat/pat policy then they will get translated otherwise they will be dropped. In the absense of the nat-control statment all packets will be allowed through translated or not - off course the non-translated ip's must be publicly routable.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...