02-20-2002 06:06 AM - edited 03-08-2019 09:52 PM
Hi,
I have defined a global address range and a PAT address for the NAT translations, so far when i view xlate translations I see the PAT address translating.
When would the other global adresses be used? I understand that PAt can carry out 64000 translations.
02-20-2002 07:51 AM
I am not sure, but if you are using an older version your PAT address should be the lowest IP address. Check your documentation to verify my statement
02-21-2002 01:20 PM
I am not sure why this happens and check the configuration for the global range.
As I understand the global range should get used up and then the PAT address will come into picture.
02-25-2002 01:53 PM
I am not sure why this is happening either. The global addresses are suppose to be used first. Try using the first available address in your range for the global and then last address for the PAT. Then do a clear xlate command. ie.
global (outside) 1 xxx.xxx.xxx.xx1 - xxx.xxx.xxx.xx4
global (outside) 1 xxx.xxx.xxx.xx5
Don't forget to do a clear xlate.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide