Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

NAT HELP

Hi,

I trying to setup multiple subnet for the nat range using private address of 10.10.1.0-10.10.16.0 under the same NAT ID of 1.

Is this possible, or would I have to assign each subnet with a seperate Nat ID. for outside connections

Thanks

1 REPLY
New Member

Re: NAT HELP

If you want to use a single NAT id, use the following command:

nat (inside) 1 10.10.1.0 255.255.240.0

nat (inside) 1 10.10.16.0 255.255.255.0

following by a global command that matches your NAT id.

92
Views
0
Helpful
1
Replies
CreatePlease to create content