Hi All,
I'm having problem on nat using Cisco ASA ver. 8.2 see below configuration...
interface Ethernet0/0
nameif outside
security-level 0
ip address 2XX.1XX.2XX.218 255.255.255.248
!
interface Ethernet0/1
nameif inside
security-level 100
ip address 172.19.190.253 255.255.255.0
!
interface Ethernet0/2
nameif inside_internet
security-level 100
ip address 192.168.20.254 255.255.255.0
!
interface Ethernet0/3
nameif EL_internet
security-level 100
ip address 192.168.220.178 255.255.255.252
nat-control
nat (inside_internet) 1 192.168.20.0 255.255.255.0
nat (inside) 0 access-list inside_nat0_outbound
nat (inside) 1 0.0.0.0 0.0.0.0
nat (EL_internet) 1 192.168.30.0 255.255.255.0
route outside 0.0.0.0 0.0.0.0 2XX.1XX.2XX.217 1
route inside 172.18.2.77 255.255.255.255 172.19.190.254 1
route inside 172.18.2.100 255.255.255.255 172.19.190.254 1
route inside 172.18.2.101 255.255.255.255 172.19.190.254 1
route EL_internet 192.168.30.0 255.255.255.0 192.168.220.177 1
route EL_internet 192.168.211.244 255.255.255.252 192.168.220.173 1
route EL_internet 192.168.220.172 255.255.255.252 192.168.220.177 1
route EL_internet 192.168.220.180 255.255.255.252 192.168.211.246 1
access-list out-gate extended permit tcp object-group Ecoland_internet any
access-list out-gate extended permit udp object-group Ecoland_internet any
object-group network Ecoland_internet
network-object 192.168.30.0 255.255.255.0
Currently my ASA has DHCP enabled for inside_internet E0/2 of ASA (192.168.20.0) and natting on outside interface...
Now my problem was natting on E0/3 to same public IP.....E0/3 is connected to a cisco 3560 switch from w/c the 192.168.30.0/24 users resides
