Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

nat (outside) 0 in ASA

Was nat (outside) 0 introduced in ASA 7.1

1 REPLY

Re: nat (outside) 0 in ASA

Hi,

This command is available in PIX 6.x.

".. Use a 'natid' of 0 with the 'outside' option to disable address translation of hosts residing on the lower security interface. Use this option only if outside dynamic NAT is configured on the interface. By default, address translation is automatically disabled for hosts connected to the lower security interface.."

More info is available at:

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a00800eb71e.html#wp1063701

Rgds,

AK

332
Views
0
Helpful
1
Replies
CreatePlease to create content